DEUTSCH HD30 Series connectors are constructed from a metal shell developed to meet the needs of the heavy duty equipment and transportation industries. The HD30 features include quick connect-disconnect bayonet cou- pling, single hole bulkhead mounting, silicone seals, and a rear insertion/rear removal contact system.
DEUTSCH electrical connectors will stand up to the harsh environmental challenges that are common to industrial markets that require advanced performance. Proper parts, procedures, and tooling must be used.
Operating at temperatures from -55° C to +125° C continuous at rated current.
No electrical or mechanical defects after 100 cycles of engagement and disengagement.
No unlocking or unmating and exhibits no mechanical or physical damage after sinusoidal vibration levels of 20 G’s at 10 to 2000 Hz in each of the three mutually perpendicular planes. No electrical discontinuities longer than 1 microsecond.
No unlocking, unmating, or other unsatisfactory result during or after 50 G’s in each of three mutually perpendicular planes. No electrical discontinuities longer than 1 microsecond. MIL-STD 202, Method 213, Condition “C”.
Connectors show no damage when exposed to most fluids used in industrial applications.
1000 megohms minimum at 25° C.
Properly wired and mated connections will withstand immersion under three feet of water without loss of electronic qualities or leakage.
Dielectric Withstanding Voltage
Current leakage less than 2 milliamps at 1500 VAC.
No cracking, chipping or leaking after 20 test cycles from -55° C to +125° C.
Deutsch HD30 Series Installation Instructions:
- Grasp contact approximately (25.4 mm) one inch behind the contact crimp barrel.
- Hold connector with rear grommet facing you.
- Push contact straight into connector grommet until a positive stop is felt. A slight tug will confirm that it is properly locked in place. NOTE: For unused wire cavities, insert sealing plugs for full environmental sealing.
- With rear insert toward you, snap appropriate size extractor tool over the wire of contact to be removed.
- Slide tool along into the insert cavity until it engages contact and resistance is felt.
- Pull contact-wire assembly out of connector. NOTE: Do not twist or insert tool at an angle.