LED Autolamps Adjustable Flash Unit
The Safety Flash Unit is designed to assist vehicles who pull up on the side of the road and wish to draw attention to the fact that they are parked or stationary to passing vehicles. Examples of the application are in a break down situation or for a road side delivery / service vehicle.
Two or more rear facing amber lights mounted on the vehicle at the passing driver’s eye level is a more effective method of attracting the attention of the passing driver. Hazard lights can sometimes be below the drivers eye line and are often confused as indicators or signalling a change of lane rather than the fact that you are stationary.
The Safety Flash Unit reduces this problem by allowing the operator to turn on the rear facing lights in the cabin before exiting. With the unit in front of the operator, you can adjust the speed of the alternating flash rate according to your requirements. LED’s on either side of the flash rate knob indicate the flashing rate.
Part No: SFU1
Voltage: 12 or 24 volt DC capable
Packaging: Blister of 1
Output: 2 Channels, 1 Amp which equates to 4 LED Amber lamps per channel
Fitting: Installation, two available options:
1 - Use double sided tape to attach to dashboard, supplied with unit.
2 - Open the case from the right hand side using a flat blade screw driver, and use the 2 screw positions to screw the base to the dashboard.
Then replace the lid of the case.
Important installation note: It is important to consider the mounting location of the rear facing lights to keep them away from the existing indicator lights on the vehicle. To obtain the best possible attention from other drivers, mount the 2 rear facing lights on each side of the vehicle – effectively allowing as much distance between the 2 lights as possible.