DuraLED® M Combi
Combination Signal Lamp
DuraLed® M Combi are “Fit and Forget” stop/tail/indicator combination signal lamps, utilising the latest LED technology, and engineered specifically for ultra heavy-duty applications on mining equipment and service vehicles.
DuraLed® M Combi lamps are extremely robust, fully sealed truly “ï¬t and forget” products, tolerant to severe vibration levels and very compact in design. A high impact and shock resistant clear XYLEX® lens is permanently bonded to a rugged, UV damage-resistant composite base for increased mechanical strength and maximum durability. HELLA engineered DuraLed® M Combi lamps to ensure a very long service life and no lighting loss due to internal dirt build-up; they are also very well suited to wet and corrosive environments and tolerate short-term immersion. (See technical section for more XYLEX® information.)
Unlike normal signal lamps, DuraLed® products are maintenance free and extremely power efï¬cient, which greatly reduces both operating temperature and demand on the vehicle’s electrical system. Maximum service life and light output of the high intensity LEDs is ensured by using internal heat sinks. The integral Multivolt™ control module also protects the DuraLed® M against damage from overheating, reversed polarity and short circuits. (See technical section for more Multivolt™ information.)
Safe and reliable electrical connection is facilitated via a highly ï¬‚exible double insulated cable sealed into the base, terminated as a short length with a DT connector or 2m cable with tinned wire ends. Other connector options can be supplied as special orders.
DuraLed® M Combi lamps are equipped with advanced, clear micro optic lenses to prevent the hazardous occurrence of “ghost” signals by internally reï¬‚ected light from other sources.
The smooth ergonomic design and very low proï¬le (under 35mm) allows DuraLed® units to be installed on almost any surface.
- Impact resistant smooth Xylex lens
- Clear precision micro optics
- Multivolt™ 8-28V DC Low power < 10W Fully sealed “fit and forget” design
- 0.5kg mass
- 200G shock impulse resistant
- Overheat, reverse polarity and short circuit protection
- Double insulated supply cable with DT plug or tinned wire
- Tested over a –40ºC to +70ºC temperature range
- High efficiency, long life LED light
- UL94 flame retardant rated external parts
- ADR, ECE and SABS compliant
- Spares interchangeable with HELLA DuraLED range
- CE compliant
All HELLA Mining LED products are covered by a five (5) year warranty on light output, excluding environmental and physical damage.