DRC Series

DRC Series

Deutsch DRC Series

The environmentally sealed DRC Series is a rectangular connector series that offers insert arrangements of 24, 40, 50, 60, 64, 70, 76, and 80 cavities and accept size 12, 16, and 20 contacts. Several mounting options are available including in-line, flange mount, and PCB mount.

DEUTSCH electrical connectors will stand up to the harsh environmental challenges that are common to industrial markets that require advanced performance. Proper parts, procedures, and tooling must be used.

Key Features

  • Accepts contact sizes 16 (13 amps) and 20 (7.5 amps)
  • 14-22 AWG
  • 24, 38, 40, 50, 60, 64, 70, and 80 cavity arrangements
  • In-line, flange, or PCB mount
  • Rectangular, thermoplastic housing
  • Jackscrew for mating

Material Specifications

  • Grommet: Silicone rubber
  • Insert Retainer: Thermoplastic
  • Jackscrew: Steel
  • Receptacle Threaded Inserts: Steel/Brass
  • Shell: Thermoplastic

DRC Series Configurations

 

Performance Specifications

DEUTSCH electrical connectors will stand up to the harsh environmental challenges that are common to industrial markets that require advanced performance. Proper parts, procedures, and tooling must be used.

Temperature

Operating at temperatures from -55° C to +125° C continuous at rated current.

Durability

No electrical or mechanical defects after 100 cycles of engagement and disengagement.

Vibration

No unlocking or unmating and exhibits no mechanical or physical damage after sinusoidal vibration levels of 20 G’s at 10 to 2000 Hz in each of the three mutually perpendicular planes. No electrical discontinuities longer than 1 microsecond.

Physical Shock

No unlocking, unmating, or other unsatisfactory result during or after 50 G’s in each of three mutually perpendicular planes. No electrical discontinuities longer than 1 microsecond. MIL-STD 202, Method 213, Condition “C”.

Fluid Resistance

Connectors show no damage when exposed to most fluids used in industrial applications.

Insulation Resistance

1000 megohms minimum at 25° C.

Moisture Resistance

Properly wired and mated connections will withstand immersion under three feet of water without loss of electronic qualities or leakage.

Dielectric Withstanding Voltage

Current leakage less than 2 milliamps at 1500 VAC.

Thermal Cycle

No cracking, chipping or leaking after 20 test cycles from -55° C to +125° C.

Deutsch DRC Installation Instructions

Contact Insertion

  1. Grasp contact approximately 1.00″ (25.4 mm) behind the contact crimp barrel.
  2. Hold connector with rear grommet facing you.
  3. Push contact straight into connector grommet until a positive stop is felt. A slight tug will confirm that it is properly locked in place.

Contact Removal

  1. With rear insert toward you, snap appropriate size extractor tool over the wire of contact to be removed.
  2. Slide tool along wire into the insert cavity until it engages contact and resistance is felt. NOTE: Do not twist or insert tool at an angle
  3. Pull contact-wire assembly out of connector.

46 Item(s)

per page

46 Item(s)

per page